Component layout on PCB

Reading Netlist and placing footprints from components

Select Read Netlist from Upper Toolbar. Click on Read Current Netlist.

Placing components on PCB

Click on component to select it and use the M key to move and the R key to rotate. 
Place all components on board to match in picture.

Connecting the components in the schematic

Select Place Wire from right side tool bar
Draw a wire from the Pin 6 of the Pin Connector to Pin 8 of the RTC
Select R1 and move to connect to the wire that was just created.
Select R2 and move to connect to the wire that was just created.
Select Place Symbol and then type VCC in pop up search window. Place just above the wire as seen in Fig 2.

---